Kit Pinguino 26j50

Pinguino 26j50 comes pre-programmed with Pinguino's USB bootloader firmware (v4.x), so you won't even need a programmer for it.

KIT CONTENTS

• 1 x PIC18F26J50 (DIP package - USB Bootloader (v4.x) is pre-installed on the chip.)
• 1 x PCB (silkscreen on both sides)

​

• 1 x Push Button
• 1 x 20 MHz crystal

Resistors

• 2 x 470 Ohm
• 1 x 10 Ohm
• 1 x 10K Ohm

Capacitors

• 2 x 22pF
• 1 x 10uF
• 2 x 100nF

Diodes

• 1 x 3mm Red LED
• 1 x BZX85C3V3 (3.3V Zener Diode)

Connectors

• 1 x USB Type-B Female
• 1 x 40-pin 2.54mm header strip
• 1 x 40-pin round female header strip

 

BOARD SPECIFICATION

• USB Bootloader (v4.x) is pre-installed on the chip.
• 8-bit 12 MIPS processor core running at 48Mhz
• 64K Program Memory
• 3800 RAM bytes
• 17 digital input/output with 5 shared analog inputs,
• 2 UART for serial communications,
• 2 fast PWM output ( 3000 Hz ),
• 5 analog inputs (10-bit ADC)
• Peripheral Pin Select for mapping digital peripherals to various I/O for design flexibility,
• Hardware RTCC provides clock, calendar & alarm functions,
• Charge Time Measurement Unit (CTMU) supports capacitive touch devices,
• Operating voltage 2.0 - 3.6V, 5.5V tolerant digital inputs.

The Pinguino 26j50 is supported by the latest version of the Pinguino IDE (http://wiki.pinguino.cc).

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: